Brother printer manual feed insert paper error

1. Remove the paper tray completely out of the machine and set it to the side. - Click here for video instructions. - If there is any paper loaded into the manual feed slot, remove it. 2. Check the manual feed slot: a. With the manual feed slot extended out, look inside the tray and push the release lever (1) toward the back of the machine. b. - The machine automatically turns on Manual Feed Mode when you put paper in the manual feed slot. - If you are using paper that is longer than Letter size or envelopes with the flap on the short edge, close the paper support flap. 1. The ROM version will need to be verified on the Brother machine. Follow the steps below. Press. The display will show Manual Feed with a scrolling message to load the paper size you are printing on. 4. Use both hands to push one sheet of paper firmly into the manual feed slot until the top edge of the paper presses again the paper feed rollers. Continue pressing the paper against the rollers for about 2 seconds or until the machine grabs.

I have a Brother DW workhorse of a printer. I love the wireless/scanning/duplexing features, but am wondering if this problem is fixable. The paper starts to feed and then never quite gets grabbed coming out of the paper tray. It doesn't jam, it just doesn't feed. When I feed manually, the printer works fine, but that is a royal pain! The machine feeds paper from the installed paper tray or the manual feed slot. The names for the paper trays in the printer driver and this guide are as follows: When looking at this page, you can jump to the page for each printing method by clicking p in the table. 1 Legal or Folio size paper is not available in some regions outside the USA. Put your printer on a flat, stable surface such as a desk that is free of vibration and shocks. Put the printer near an AC power outlet, so that it can be easily unplugged from the AC power outlet if there is an emergency. Only use the printer within the following ranges of temperature and humidity.

Pull out the paper support (1) until it locks into place, and then unfold the paper support flap (2). If the document does not fit on one sheet, the machine will prompt you to load another sheet of paper. Place another sheet of paper in the manual feed slot, and follow the instructions displayed on the LCD. Brother Printer keeps reverting to manual feed We have two Windows 10 computers (bit), and a Brother HL-LDW printer that is connected via USB. This printer keeps reverting to manual feed, no matter how many times we reset the Printer Preferences to Tray 1. The MANUAL FEED message appears when the manual feed slot is selected as the default paper source in the printer driver. Check the solution applicable for your case. If you want to print from the manual feed slot, go to CASE A: Print from the Manual Feed Slot.